您当前的位置:首页>>驾校资讯>>科目三转速与档位匹配的标准

科目三转速与档位匹配的标准

来源:http://www.jiakaopeixunwang.com/ 发布时间:日期:2022-11-11
学车期间的科目三实际上挂的人不算少,很多都是不注重细节导致的,比如说科目三转速问题。下面济南驾驶培训中心来讲讲科目三转速与档位匹配的标准。
In fact, the number of students who failed in Subject 3 during the learning period was not small. Many of them failed to pay attention to details, such as the speed problem of Subject 3. Next, Jinan Driving Training Center will talk about the standards of speed and gear matching of subject 3.
(1)一档起步,稍微给气门加油至1200rpm,转速小于10KM/H,立即换到二档(短时间)。
(1) Start from the first gear, fill the valve slightly to 1200rpm, and the speed is less than 10KM/H, then shift to the second gear immediately (for a short time).
(2)在第二档,加满油门,发动机转速会上下到1500-2000rpm。这时车速会上下到30km/h,同时,抬起油门,换到三档。
(2) In the second gear, when the accelerator is fully filled, the engine speed will rise and fall to 1500-2000rpm. At this time, the speed will reach 30km/h, at the same time, lift the accelerator and shift to third gear.
(3)三挡时,加满油门,发动机转速会上下到1500-2000rpm,此时车速会上下到40KM/H,同时油门会提升,换四挡。
(3) In the third gear, fill up the accelerator, and the engine speed will rise and fall to 1500-2000rpm. At this time, the vehicle speed will rise and fall to 40KM/H. At the same time, the accelerator will rise and shift to the fourth gear.
济南驾驶培训中心
(4)四挡时,加满油门,发动机转速上下至1500-2000rpm,此时车速上下至50-70KM/H,同时换到五挡;(5)五档时,加满油门,发动机转速会上下到1500-3000rpm,车速会上下到80-120km/h。
(4) In the fourth gear, fill up the accelerator, and the engine speed will reach 1500-2000rpm. At this time, the vehicle speed will reach 50-70KM/H, and shift to the fifth gear at the same time; (5) In fifth gear, when the accelerator is fully filled, the engine speed will rise and fall to 1500-3000rpm, and the vehicle speed will rise and fall to 80-120km/h.
科目三路考的转速不能超过2000转,如果学员在考试的过程中转速超过了2000转,就会直接扣100分,考试不合格。这是因为发动机转速超过2000转是属于低档高速,而在我们的考试过程中,发动机转速应当控制在1500转左右,所以,2000转就不符合实际。而且,如果发动机达到了1800转,这时候就代表车辆属于升档行驶。
The speed of the subject three road test cannot exceed 2000 revolutions. If the speed of the student exceeds 2000 revolutions in the course of the test, 100 points will be directly deducted, and the test is unqualified. This is because the engine speed exceeds 2000 rpm, which is a low-grade high speed. During our test, the engine speed should be controlled at about 1500 rpm. Therefore, 2000 rpm is not practical. In addition, if the engine reaches 1800 rpm, it means that the vehicle is in upshift.
学员在进行科目三的考试的时候,车辆超过2000转但仍然没有换挡的,还一直处于低速档位上的情况是属于拖挡行驶,而低档高拖容易使发动机在过高的转速下运行,这种情况非常的费油,不仅如此,高速运转对发动机的部件会有过大的压力,所以,学员在进行科目三的考核时,转数是不能超过2000转的。
When the students are taking the exam of subject 3, if the vehicle is more than 2000 revolutions but still does not shift gears, and the vehicle is still in low gear, it belongs to driving in drag gear, while the low gear and high drag are easy to make the engine run at high speed, which is very fuel consuming. Besides, high speed operation will have too much pressure on the engine components, so when the students are taking the exam of subject 3, The number of revolutions cannot exceed 2000.
总之,科目三考试中,如果挡位速度匹配,发动机转速应该在1000-2000r/min之间,如果低于800r/min或高于2000r/min,说明挡位速度不匹配。更多相关学车考驾照的问题就来我们网站http://www.jiakaopeixunwang.com咨询吧!
In conclusion, in the third subject examination, if the gear speed matches, the engine speed should be between 1000-2000r/min; if it is lower than 800r/min or higher than 2000r/min, the gear speed does not match. More questions about the driver's license test can be found on our website http://www.jiakaopeixunwang.com Consult!

相关产品 / Related products

  • C2自动挡-夜间班

    C2自动挡-夜间班

  • C2自动挡-VIP班

    C2自动挡-VIP班

  • C2自动挡-快班

    C2自动挡-快班

  • C1手动挡夜间班

    C1手动挡夜间班

联系
客服

13964134659
7*24小时客服服务热线

微信
沟通

扫码微信沟通
X
友情链接: 企业上市辅导 六安驾校 宁夏家教 塑料浮体 蒸压加气混凝土墙板 工业氯化铵厂家 济宁集成房屋 四轮电动车招商代理 武安叉车 遥控锁厂家 衡阳干粉砂浆厂家